1POOL FROG® Mineral HyBrid Operations Manual for Pool Owner IMPORTANT:Register your warranty NOW.See back page or visit www.kingtechnology.comThis ma
10Cleaning POOL FROG® Mineral Hybrid CellOur clear cell allows for easy regular inspections for calcium build up. Visually check the cell periodically
11POOL FROG® Mineral Hybrid Cycler Maintenance1.2.3.Replacing the Control Dial O
12WinterizingJust like the pool plumbing, freezing may damage the system’s cell and flow sensor. If severe or extended periods of freez-ing temperatur
13PROBLEM POSSIBLE CAUSES WHAT TO DO1. Low Chlorine Residual in PoolSystem is turned off. Turn system on.Check fuse and breaker.Output level is set t
14PROBLEM POSSIBLE CAUSES WHAT TO DO7. High Salt Icon OnSalt level is very high. The generator could completely turn off and no longer produce chlorin
15Saturation IndexTest the water for pH, Alkalinity, Calcium Hardness and Temperature, then follow the simple steps below:1. Write your pool’s pH leve
16GlossarySalt: To ensure maximum benefits with the use of the sys-tem, the ideal salt level is 4000 ppm (parts per million). A low concentration of s
17POOL FROG® Mineral Hybrid Cycler Parts ListParts for the POOL FROG® Mineral HybridGenerator will be provided as needed by ourwarranty stations after
18POOL FROG® Mineral Hybrid Cycler Two-Year Limited WarrantyKing Technology, Inc. warrants to the original purchaser this cycler unit will be free fro
19POOL FROG® Mineral Hybrid Generator Three-Year Limited WarrantyThis warranty applies to the chlorine generator and their factory-sup-plied componen
2Important Safety InstructionsRead and Follow All Instructions All electrical work must be performed by a licensed electrician and conform to all nati
3TABLE OF CONTENTSImportant Safety Instructions 2Introduction 4Start-up 5Adding Salt to the Pool 6Replacing POOL FROG® Mineral Reservo
421345 6MINERALSWelcome to easier pool care courtesy of POOL FROG®. With POOL FROG®Mineral Hybrid, your pool water will look and feel better without a
5Start-up1.IMPORTANT: Pump run times of at least 6 hours at highspeed are recommended for proper performance. If run-ning on low speed only (24 hours)
6Adding Salt to the Pool1. BEFORE ADDING THE SALT• Measure existing salt in your pool: Previous use of liquid chlorine may cause the salt reading to b
7Check the front of the box and back label of the product to make sure you have the correct POOL FROG® Mineral Reservoir to fit your POOL FROG® Minera
8Basic OperationThis system is designed to work effectively witha variety of pool equipment as long as the following basic procedures are followed.1.
9Reading the Control PanelSalt ReadoutsNormal salt level:Normal salt level:Salt level is normalwhen the salt levelbar is in the “✔” area.Note: The sal
Comments to this Manuals